ISO/IEC 17025 Accreditation
Accreditation to ISO/IEC 17025 for calibrations demonstrates technical competence, accuracy of measurements and provides confidence. In most cases regulatory authorities require that calibrations be performed in an accredited laboratory. NATA accreditation to ISO/IEC 17025 is recognised and accepted globally
Service options
N.A.T.A. Dimensional Report – ISO 17025
Thread comparison to standards
Measured report – non NATA
Rework, repair, and replace options available
Applicable Standards
Applicable standard if available or customer drawing
Our laboratory is accredited to ISO 17025
Why this service is used
Sometimes it is not clear why two parts don’t assemble correctly. We can measure one or both parts and determine the cause of the problem. Dimensional reports can be issued and used to sort out the root cause.
Measurements offered
| Type | Geometrical | Machine used |
|---|---|---|
| Length | Flatness | Zeiss Prismo CMM |
| Angle | Roundness | Zeiss Prismo CMM |
| Diameter | Parallelism | Zeiss Prismo CMM |
| Squareness | Zeiss Prismo CMM | |
| Straightness | Zeiss Prismo CMM | |
| Position | Zeiss Prismo CMM | |
| Concentricity | Zeiss Prismo CMM | |
| Pitch diameter | IAC Master Scanner | |
| Major & minor diameter | IAC Master Scanner | |
| Thread angle | IAC Master Scanner | |
| Pitch error | IAC Master Scanner |
FAQs
My nut and bolt will not assemble, can you find the issue?
Yes, threads are our specialty. We can measure thread diameters and scan the thread form to find any issues. A report can then be issued with actual and specified sizes.
Can you check if my thread complies with the standard?
Yes, we can measure the thread and compare the results with the standard. A report can then be issued with actual and specified sizes.
